Bad Boy 48721201, Руководство оператора

Страница: 7 / 20

7
(Figure 7 & 8). Align the holes to each side and fasten by
using (2) 3/8”-16 x 3/4” HHCS P#(K1190) and (2) 3/8”-16
flange nuts P#(K1215) per side. Tighten all nuts and
bolts.
2-7 Lift Handle To Aluminum Grass
Container Installation
The various parts of the handle assembly P#(A0574)
must be attached to the container frame. Figure 9 shows
the orientation and location of the components. Slide the
lift handle into the slot in the handle mount bracket
P#(B1730) on the grass container. It may be necessary
to remove the handle grip P#(J0522) to allow the handle
to fit through the slot.
Before attaching the handle, hook one end of the spring
P#(J0176) into the hole on the underside of the handle.
Continued on page 12.
2-5 Cam Assembly Adjustment
The cam assembly P#(A0422), which controls the
blower belt tension, comes from the factory pre-adjusted.
If the belt is too tight or becomes too loose, remove the
hair pin clip P#(K0099) from the belt tension rod
P#(K0326) and pull the “L” end of the rod out of its hole
in the cam assembly. The tension rod may then be
screwed out to tighten the belt or screwed in to loosen
the belt. Replace the “L” end into the top hole in the cam
and replace the hair pin clip. Adjust the cam stop bolt
P#(K1159) to allow the cam to rotate slightly over center
when the blower is disengaged (Figure 6).
2-6 Top Main Frame Assembly
Installation
Place the top main frame assembly P#(A0596) on top of
the left lower main frame leg and the PTO assembly
Gear Box Assy.
Engine Pulley
Figure 5.
Belt
Cam Assy.
Tension Rod
Figure 6.
Cam Stop
Bolt
Figure 7.
Figure 8.
Left Lower Frame Leg
Fasten w/
(2) 3/8” x 3/4” HHCS
(2) 3/8” Flange Nuts
PTO Assembly
Fasten w/
(2) 3/8” x 3/4” HHCS
(2) 3/8” Flange Nuts