Bad Boy 48721201, Руководство оператора

Страница: 14 / 20

14
2-13 Lengths Of Hose Adjustment
The hoses in steps 2-14 and 2-15 must be cut to fit your
machine. Follow steps 2-14 and 2-15. Do not cut the
hoses until you have tried to fit them on your machine.
Remember that the hoses have to be long enough to
allow for enough clamping surface between the inlet,
blower assembly, and the deck boot.
2-14 Upper Hose Installation
Slide (1) 5”-6” upper hose clamp P#(J6011) onto both
ends of the 6” upper hose. Place (1) hose ring
P#(E0007) into one end of the 6” hose making sure the
hose is on at least 2”, then tighten the hose clamp.
Proceed to slide the opposite end of the 6” hose onto the
blower assembly and tighten hose clamp. Place the
hose ring onto the inlet ring and tighten the locking pin.
See Figure 19 for details. Make sure both ends of the
hose are clearly attached to the inlet and the blower
assembly outlet.
2-15 Lower Hose To Blower Cone
Installation
Slide a 7”-8” hose clamp P#(J6006) over both ends of
the lower hose. Then proceed to slide the lower hose
onto the blower cone. Tighten the hose clamp. The
assembly should look like Figure 20.
2-16 Lower Hose To Boot Installation
Take the unattached end of the lower hose and slide it
over the circular end of the boot. Use the lower hose
clamp to secure the hose to the boot (Figure 20). Tip:
Before securing clamp rotate hose counter-clockwise
(away from yourself) approximately 1” to add in retaining
boot to mower deck.
2-17 Front Weight Installation
Slide the weight bracket assembly P#(A0597) into the
mower’s front receiver hitch (Figure 21). Fasten by using
(1) 5/8” x 3” clevis pin P#(K0172) and (1) 5/32” x 2-5/8”
hair pin clip P#(K0088). When installing the weight bar
(Figure 22) P#(B2220), you should have another person
help position the weight centered onto the weight
bracket assembly. Fasten the weight by using (2) 1/2”-13
U-bolts P#(K0331) and (4) 1/2”-13 flange nuts
P#(K1246). Tighten all nuts and bolts.
Figure19.
Inlet Ring W/Locking Pin
6” Hose Ring
5”-6” Hose Clamp
6” Upper Hose
Figure 20.
Blower Housing
Blower Cone
8” Lower
Hose
Boot
7”-8” Hose
Clamp
Figure 21.
Figure 22.
Fasten w/
(1) 5/8” x 3” Clevis Pin
(1) Hair Pin Clip
Fasten w/
(2) ½” U-Bolts
(4) ½” Flange Nuts