10
11
% BAC
% BAC
% BAC
% BAC
% BAC
% BAC
Step 4:
When the countdown reaches zero,
the BACTRACK will beep and a red dot will
appear. Blow through the mouthpiece
continuously for five seconds until the beep
sound comes on and then stops.
STEP 5:
Once the sensor has analyzed
the breath sample, the estimated BAC value
is displayed.
NOTE: For most accurate results, wait one minute
between tests. When testing high alcohol levels,
wait 3-5 between tests.
Display shows ‘FL’
The user did not provide a sufficient breath
sample. Please retest and blow steadily and
continuously for 5 seconds.
Display shows ‘H’
Reading exceeds upper limit of .40% BAC.
Make sure user has waited 20 minutes after
consuming alcohol before blowing.
Display shows ‘Er’
The sensor is damaged. Contact support
for assistance.
Display shows ‘Lo’
Low battery. Replace with a new AAA
alkaline battery.
SPECIFICATIONS
Dimensions
1.45 x 0.55 x 2.44 inches
(3.7 x 1.4 x 6.2 cm)
Weight
2 oz. (56 grams)
Sensor Technology
Advanced Semiconductor
Detection Range
0.00 - 0.40 %BAC
Power Supply
One AAA battery - not included
Battery Life
150 tests
Warm Up Time
11-13 seconds
Response Time
5 seconds
Operating
Temperature
50 - 104 degrees Fahrenheit
(10 - 40 Celsius)
This device has been tested using NHTSA/DOT procedures. In
this testing, the accuracy of this device was established at Blood
Alcohol Concentrations (BAC) of 0.008 and 0.032, but not at
greater concentrations. Additional laboratory testing has been
performed at concentrations ranging from 0.00 – 0.40% BAC.
