TF2089904-KK-00 Eng Page 21 of 22 20150422 V.1
Trouble Shooting
PROBLEM
POSSIBLE CLAUSE
CORRECTIVE ACTION
The burner does not light up
The connection between the regulator
and LP Tank are not in good condition.
Check and make sure the regulator coupling nut is
tightened to the LP tank valve.
The LP tank valve and regulator control
valve do no open.
The regulator control valve and LP tank valve is
open during normal operation. The regulator
control valve is opened in clockwise direction and
the LP tank valve is opened in counter-clockwise
direction.
The LP tank is empty.
Check and make sure the LP tank is filled with
fuel.
Push button of safety valve was not
pushed down.
Press and fully hold down push button of safety
valve after the lighted match is placed on the
burner.
The burner does not stay lit
The push button on safety valve was
not fully pushed down for at least 10
seconds.
Fully hold down the push button on safety valve at
least 10 seconds and then release.
Timer is not activated.
Fully turn the timer control knob clockwise.
The thermocouple is not in direct flame
path of burner.
Ensure the thermocouple is assembled in right
position and the nut is tightened on the
thermocouple. (See Assembly Instruction - step 2
for detail) Make sure the flame has full contact with
the thermocouple.
High wind condition.
If wind blows out flame, gas supply will be cut off.
Move out of wind and restart.
Timer has completed its cycle.
Each cycle of timer is 15 minutes, after 15
minutes, the burner will go off automatically.
Please re-set the timer.
The oil is not reaching
desired temperature.
The food is not fully defrosted.
Do not attempt to fry a frozen or partially frozen
turkey or food. Ensure the turkey or food is
completely thawed prior to proceeding
The regulator control valve is not fully
opened.
Fully open the regulator control valve. The
regulator control valve is opened in clockwise
direction and the LP tank valve is opened in
counter-clockwise direction.
Overfilled Protection Device (OPD) on
tank has been tripped.
Overfilled Protection Device (OPD) has been
activated. To reset, turn off regulator control valve
and LP tank valve. Disconnect the regulator from
the LP tank and wait one minute. Reconnect the
regulator control valve to the LP tank valve and
slowly open the LP tank valve until it is fully open.
