Backyard TF2089904-KK-00, Руководство по сборке, использованию и уходу

Страница: 10 / 22

TF2089904-KK-00 Eng Page 10 of 22 20150422 V.1
CAUTION
If burner does not light OR if burner flame is accidentally extinguished, turn knob to OFF,
wait 5 minutes, try again. If the burner does not ignite with valve open OR if burner flame is
accidentally extinguished after lighting, gas will continue to flow out of the burner and could
accidentally ignite with risk of injury.
Burner Flame Check

Light burner, rotate knob from HIGH to LOW. You should
see a smaller flame in LOW position than seen on HIGH.
Always check flame prior to each use. The air damper (D)
mounted on the back of your burner helps to control the
amount of primary air that mixes with the LP gas. A blue
flame with little or no yellow flame provides the best heat.
Adjust the air damper by turning it clockwise or
counterclockwise until the desired flame is achieved.
Turning LP Cooker Off

Turn all knobs to OFF position, Turn LP tank OFF by turning
hand-wheel clockwise to a full stop.
Regulator and Hose Assembly Check

Before each use, check to see if there is evidence of
abrasion, wear, cuts or leaks, the hose assembly and
regulator must be replaced prior to the appliance being put
into operation. The replacement hose assembly and regulator shall be that specified
by the manufacturer.
Cleaning the Burner
CAUTION
Checking and cleaning burner / venture tubes for insect nests. A clogged tube can lead to
fire beneath the appliances.
Spiders‟ nests or wasps‟ mud inside the burner may cause fire at the air damper. If a fire
occurs, immediately turn off gas supply at LP tank valve.
Note :
Spiders and small insects can spin webs and build nests inside the burner. This especially
occurs in late summer and fall before frost when spiders are most active. These nests can
obstruct gas flow and cause a fire in and around the burner and orifice. Such a fire can
cause operator injury and serious damage to the appliance.
To help prevent a blockage and ensure full heat output, clean and inspect burner tube often
(once or twice a month). NOTE: Water or air pressure will not normally clear a spider web.