TF1008-011991-T ENG
P.5
22062011
DANGER
z
The safety relief valve on the LP tank could activate releasing gas and cause an intense fire with risk of death
or serious injury. Therefore, follow instructions bulleted below exactly.
(a)
Do not store a spare LP-gas cylinder under or near this appliance.
(b)
Never fill the cylinder beyond 80 percent full; and
(c)
If the instructions in (a) and (b) are not followed exactly, a fire causing death or serious injury may occur.
z
If you see, smell, or hear escaping gas, immediately get away from the LP tank/appliance and call your fire
department.
z
All spare LP tanks must have safety caps installed on the LP tank outlet.
WARNING
Clean and inspect the hose assembly / regulator before each use of the appliance.
If there is evidence of abrasion, wear, cuts or leaks, the hose must be replaced
prior to the appliance being put into operation.
LP Tank Removal, Transport and Storage
z
Turn OFF all control knobs and LP tank valve. Turn coupling nut counterclockwise by hand only – do not use
tools to disconnect. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the
type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs
may result in leakage of propane.
z
A disconnected LP tank in storage or being transported must have a dust cap
installed (as shown). Do not store an LP tank in enclosed spaces such as a
carport, garage, porch, covered patio or other building. Never leave an LP
tank inside a vehicle which may become overheated by the sun.
z
Do not store LP tanks in an area where children play.
LP Tank
The LP tank used with your appliance must meet the following requirements:
z
Purchase LP tanks only with these required measurements: 12” (30.5cm) (diameter) x
18”(45.7cm)(tall) with 20lb. (9kg). Capacity maximum.
z
The LP-gas supply cylinder to be used must be constructed and marked in accordance with
the specifications for LP-gas cylinders of the US Department of Transportation (DOT) or the
National Standard of Canada, CAN/CSA-B339, Cylinders, Spheres and Tubes for the
Transportation of Dangerous Goods.
LP tank valve must have:
z
Type 1 outlet compatible with regulator or appliance.
z
Safety relief valve.
z
UL listed Overfill Protection Device (OPD). This OPD safety feature is identified by a
unique triangular hand wheel. Use only tanks equipped with this type of valve.
LP tank must be arranged for vapor withdrawal and include collar to protect LP tank
valve.
LP (Liquefied Petroleum Gas)
z
LP gas is non toxic, odorless and colorless when produced. For your safety, LP gas has
been given an odor (similar to rotten cabbage) so that it can be smelled.
z
LP gas is highly flammable and may ignite unexpectedly when mixed with air.
LP Tank Filling
z
Use only licensed and experienced dealers.
z
LP dealer must purge tanks before filling.
z
Dealer should NEVER fill LP tank more than 80% of LP tank volume. Volume of propane in tanks will vary by
