TF1008-011991-T ENG
P.11
22062011
Assembly Instructions:
1. Attach cast iron burner (4) to automatic shut off valve (V) in the
timer control box (3) by turning the cast iron burner clockwise.
Do not fully tighten cast iron burner to the valve, tighten until
3
threads
remain visible on the valve. Attach thermocouple (D) to
thermocouple bracket (E) which has been fixed to the cast iron
burner.
2. Attach thermocouple (D) as per right drawing and tighten the
nut (Y).
3. Insert cast iron burner (4) through the bottom of the stand, in
between wind shield (F) (side with rectangle lip) and burner
support bar (G).
4. Unscrew the pre-assembled nut from the threaded pin of the
cast iron burner (4). Align timer control box (3) to the timer box
support bar (2) and fix it with 2 pieces M6x12 bolts (A) by going
through the support bar (2) and then to the time box (3). Then
align burner (4) base to burner support bar (G). Align holes on
heat shield (7) with threaded pin and alignment pin of cast iron
burner (4) through hole in burner support bar(G), then through
small hole of heat shield (7). The alignment pin on bottom of
burner (4) must be inserted through the large hole of the heat
shield (7), Tighten hex nut onto bolt of cast iron burner (4).
Finally, fix the support bar (2) to legs of stand with 2 pieces
M6x12 bolts (A) by going through the holes on legs and then
through the holes of support bar (2). Tighten the bolts with 2
pieces M6 nuts (B).
Proper connection is critical for correct operation of unit
4
