CORNER.
2.2 - IF POST ANCHOR IS TO CLOSE TO CONCRETE SLAB EDGE, POST ANCHOR CAN BE MOVED TO INSIDE
TEMPORARILY PLACE THE POST ANCHORS TO THE OUTSIDE CORNERS OF POST AND TRANSFER ONLY ONE
ON
CONCRETE SLAB USING A MASONRY BIT AND ROTARY HAMMER DRILL.
2.4 - REPEAT SUB-STEPS 2.1 TO 2.3 ON ALL FOUR POSTS. CLEAR HOLES AND ATTACH ONE 3/8" X 3"
TITEN BOLTS
2.1 - ATTACH STANDOFF TO POSTS WITH (2) 3-1/2" DECK SCREWS PRIOR TO STANDING UP THE POSTS.
EACH HOLE POSITION. WITH HELP PLUMB POST WITH LEVEL.
CENTER HOLE PER POST ANCHOR TO THE CONCRETE SLAB AS SHOWN BELOW.
STEP 2: POST ANCHORS
2.3 - REMOVE POST ANCHORS AND USE CENTER MARK TO DRILL A 3/8" HOLE AT LEAST 3" DEEP INTO THE
NOTE: POST WILL MOVE SLIGHTLY UNTIL HEADERS ARE INSTALLED
2.5 - SECURE ALL POST ANCHORS TO POSTS WITH #9 X 1-1/2" SD CONNECTOR SCREW THROUGH EACH HOLE
POSITION. REPEAT ON ALL FOUR POSTS.
#9 X 1-1/2" SD
CONNECTOR SCREW
POST ANCHOR
STANDOFF
3-1/2" WOOD SCREW
OPTIONAL INSIDE CORNER
3/8" X 3"
CONCRETE ANCHOR
8
