SKU 272-0095/FC-30-MN
09
© 2018 Jack-Post Corporation 09/18
FINAL ASSEMBLY
STEP 1
Attach two tubular legs to angle bracket with 2" slotted head screws and 1/4" hex nuts.
STEP 2
Fasten the two tubular legs together with two 2-5/8" slotted head screws, fastening brace between legs through hole, as shown.
THIS
ANGLE
MUST BE
90º
BRACE
TABLE
2" CARRIAGE
1/4" HEX NUT
1/4"
HEX NUT
1/4"
HEX NUT
1/4" HEX NUT
LEG
BRACE
2-5/8"
SLOTTED
SCREW
2" CARRIAGE BOLT
NO CENTER CLEAT ON 4
'
TABLE
LEG ASSEMBLY
2"
SLOTTED
SCREW
STEP 3
Make sure tubular leg assembly is at a right angle(90
º
) to the table top. Bend brace so that it lays flat against table top.
Locate the point at which hole in brace contacts the table top and drill 1/4" diameter hole, as shown.
Brace may fall on either side of center cleat depending on length of table being assemble. No center cleat used on 4
'
table.
STEP 4
Attach brace to table top with 2" carriage bolt and hex nut as shown above.
STEP 5
Repeat STEPS 1 - 4 for opposite end of table top.
STEP 6
Turn table over and mount benches to leg assemblies with 1/4" hex nuts.
1/4" HEX NUT
1/4" HEX NUT
STEP 7
Tighten all bolts.
MAINTENANCE INSTRUCTIONS:
PERIODICALLY CHECK ALL HARDWARE TO BE SURE BOLTS AND NUTS ARE TIGHT.
