8
Figure 4a Figure 4b
5. With the help of another person, carefully place the table top onto the firepit base. After
making any necessary adjustments to the alignment of the table top and the assembled base,
use four 1/4"x40 mm bolts and Ø20xØ6.5x2.0 mm as shown in Figure 5.
Hand tighten only.
Figure 5
6. After making any necessary adjustments to the alignment of the unit, use the hex bolt driver
to tighten all bolts. Repeat until all bolts are tight. Do not over tighten. Over tightening may
strip bolts.
7.
Place the burner pan protective ring into the firepan/burner assembly as shown in Figure 6.
Align the holes in the burner pan protective ring with the pre-drilled holes on the firepan/burner
assembly. Secure the burner pan protective ring to the firepan/burner assembly by using the
two M4 screws as shown in Figure 6.
Figure 6
