INSTALLER NOTES
After the installation of the system is complete, make sure to adjust the direction of the sensors
to correct any range problems you might be experiencing such as false alerts or no alerts at all.
If need be, the provided plastic shims can be used to adjust the angle of the sensors on the
bumper.
1.
When installing the system, the car should be completely powered off. It might be a good
idea to remove the negative battery terminal in some vehicles prior to installation.
2.
The operation of the system may be affected by certain conditions such heavy rain,
gravel roads, sloping surfaces, bushes, extreme hot or cold weather or if the sensors are
covered by snow, ice, mud, etc.
3.
Other ultrasonic or electronic fields such as other electrical devices or high current power
wires in the vehicle may effect the operation of the sensors.
4.
The sensors should not be installed too tightly or too loose in the bumper
5.
Do not install the control module any other high current electrical devices or wires under
the dash board or in the truck. If installing in the trunk, make sure the control module is
away from any moisture or weather elements.
6.
Bench test the system first to make sure the operation is good before drilling the holes in
the bumper. Once tested and installed, make sure to practice test the system in a parking
lot before actual use.
7.
The 3M double side tape for the control module, monitor and buzzer cannot be used
twice. Use an alcohol wipe to make sure the mounting surface is clean before use. If
sticking to a vinyl or color surface, be cautious when using alcohol wipes to make sure
the surface does not become damaged or discolored.
8.
Use only the provided hole saw bits to drill the holes for the sensors and camera.
TECH SUPPORT: (800) 998-6880
SPECIFICATIONS:
Supply Voltage:
DC 12 Volt
Operational Voltage:
10.5 ~ 16 Volts DC
Current Consumption:
40mA ~ 300mA
Detection Distance:
5” ~ 8’3” behind the vehicle
Ultrasonic Frequency:
40 KHz
Working Temperature:
System: -40°F - 176°F / Monitor: 32°F - 140°F
Control Module Dimensions (MM):
82 (L) × 80 (W) × 23 (D)
Hole-Saw Size (MM):
Sensors: 21 / Camera: 18.5
Camera Viewing Angle:
Horizontal: 170° / Vertical: 90°
Resolution:
420 TV Lines
Image Sensor:
CMOS
TV System:
NTSC / PAL
Содержание CA-5030
Страница 16: ......
