5
Assembling your Back Bubble
TM
Your Back Bubble
TM
is already pre-assembled. Wear comfortable clothes with tennis shoes or other non-
slipsole shoes while using the Back Bubble
TM
.
1) Installing the EZ Hanger bar
• Please refer to the EZ Hanger instruction
sheet, provided inside the hardware bag
or online at: www.trybackbubble.com.au or
www.trybackbubble.co.nz
2) To Inflate the Back Bubble
TM
• Twist the Valve Tip to the left to open,
then blow into it. When complete, close
the Valve Tip by turning it to the right.
• Fill to about 70% capacity (the Back
Bubble
TM
should look like Fig. 5)
• Use the side of your hand to crease
the Back Bubble
TM
’s center and make
a point (Fig. 1 & 5)
• Your Back Bubble
TM
should look like
(Fig. 5) with a 5cm to 25cm opening
at the top
• Adjust comfort by opening the
Valve Tip by turning it to the left
to let air out. When desired level
is reached twist the Valve Tip to
the right to close.
3) Adjusting the Height of the Back Bubble
TM
• Raise or lower the Back Bubble
TM
by
pressing the Adjustment Buckle (Fig. 4)
and pulling the strap downward firmly.
4) The Comfort Spreader (optional)
• The Comfort Spreader is normally used only for
the Upright Positions to open the Back Bubble
TM
wider, for additional comfort on the ribs.
• If you ordered a Comfort Spreader (optional), the
Back Bubble will hang from it using the
2 rings on the ends of the Back Bubble
TM
(See Comfort Spreader Instructions, page 13)
Tip:
The Back Bubble
TM
can also hang from a
sturdy hook, rope or chain (min. 226kg) properly
installed by a professional into a ceiling joist or
beam approximately 2.13m from the floor.
That’s it! You’re ready to go!
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
BackBubble_IM_ENG_06-16 ANZ-BDV1.indd 5
28/06/2016 10:07:02 a.m.