Bacharach Parasense GRM2 CO2 Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 41 / 97

7-5
Operation & Maintenance Manual
Doc. Ref. MNGRM2CO2 REV. 3
REPLACING THE ENCLOSURE DOOR
IMPORTANT: Before powering off the system to remove the door:
1. If you have changed the default passcode, make a note of your passcode.
2. Using the latest version of the GRM2 configuration t
ool, ‘Load’ the configuration from the
GRM2. In order to do this you will need a working network connection to the GRM2 (refer to
section 4) and you will need to know the IP address of the GRM2 (refer to section 5-8)
You can now follow the below procedure for removal and refitting. When the door replacement is
finished, and the system is powered back on:
3.
Adjust the display contrast as required (refer to section 5-1)
4. Using the latest version of the GRM2 configuration t
ool, ‘Load’ the configuration obtained in
step 2 above and send this to the GRM2. You will need a working network connection to the
GRM2. The IP address of the GRM2 should be unchanged from that used in step 2 above.
5. Using the GRM2 display, enter the management menu and change the default passcode to
your passcode (as noted in step 1), refer to section 5-10
Procedure for removal and refitting:
Switch off the mains supply to the monitor
and wait for a few seconds while the power
supply discharges. Open the enclosure door
with the key provided and switch off at the
internal power input module by pressing the
red button
(1) .
Disconnect the display lead (2) . Unscrew the
clips holding the cable in position (3) and
remove cabling from the enclosure door.
1
2
3