Bacharach Parasense GRM2 CO2 Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 22 / 97

3-1
Operation & Maintenance Manual
Doc Ref. MNGRM2CO2 REV. 3
4 SETTING A WINDOWS PC TO COMMUNICATE WITH A
GRM2 CO2
Communication with the GRM2 CO2 utilises the Ethernet socket mounted on the network module. A
Cat5/Ethernet cable can then be plugged into the Ethernet socket, with the other end plugged into the
Ethernet port of a PC running Windows XP or later.
The PC must have its local area network information configured to a range that will allow it to
communicate with the GRM2 CO2. The exact terminology varies slightly between different versions
of the Windows operating system. The instructions below are for Windows 10/Windows 8 with
variations for Windows 7. Windows XP is covered separately.
WINDOWS 10, 8 and WINDOWS 7
1) Take a note of the current network settings of the GRM2 CO2 system (please refer to the Network
Settings menu of the Monitor Setup/Management Menu section for information).
2) From the PC Desktop, access the control panel:-
Using Windows 10 or 8: Pres
s and release both the ‘Windows’ key and ‘X’ key at the
same time. Click ‘Control Panel’.
Using Windows 7: Click ‘Start’, ‘Control Panel’.
3)
Under ‘Network and Internet’ of the control panel, click ‘View network status and tasks’.
4)
Click ‘Change adapter settings’ in the left hand menu. Right-click ‘Ethernet’ or ‘Local Area
Connection’ and choose ‘Properties’ from the popup menu.
5)
From the list shown, select ‘Internet Protocol Version 4 (TCP/IPv4)’ then click the ‘Properties’
button.
2