Manual Part Number:
5-06-7000-80-0
Manual File:
012476 Rev. A
Page 2-17
2.4 Testing the Refrigerant
After the air calibration is complete, the instrument is ready for testing. The analyzer will
direct you to connect the hose to a refrigerant source as shown in (
Figure 7)
. Connect the
hose to the vehicles Low Side Schrader valve, or connect it to the Low Side Port on a
refrigerant cylinder, and open the valve. Allow the refrigerant to flow for a few seconds and
then press the ‘Test’ button to begin the test. The Testing screen shown in (
Figure 8)
will
display.
2.5 Viewing the Test Results
Upon completion of testing, the
Legend ID™
will display (
Figure 9)
. Disconnect the coupler
from the refrigerant source and select ‘Results’ to display the test results (
Figure 10).
The
percentage displayed for each refrigerant indicates the total purity weight of that
refrigerant, equaling 100%, with air and non-condensable gases measured independently.
Pressing ‘Print’ will print the test results. Pressing ‘Print Prior 5 Results’ will print the last 5
tests completed.
Figure 8
Figure 9
Figure 10
Figure 7
