Bacharach Fyrite Pro, Руководство по эксплуатации и техническому обслуживанию

Страница: 32 / 64

Instruction 0024-9395 26
Fyrite Pro
4.8 Printing Test Data
Tip:
To avoid printing errors, it is important to select the
correct protocol per Section 3.5.8 before saving data.
Turn ON the printer. Refer to the printer’s instruction manual for detailed
operation and maintenance information.
If not already done, set the printer parameters as follows:
• Data: 8 bits • Parity: None
• Baud: 9600 • Handshaking: X-on/X-off
Align the printer with the top of the analyzer as shown in Figure 4-1.
The next step in the printing procedure depends on the model of the ana-
lyzer, and whether the operator desires to print only the current test data,
or all stored test data starting with the most recent. Perform the appropri-
ate procedure below:
Model 100 – Print Current Test Data
With the analyzer in its Run Mode, begin printing by pressing the
HOLD
button twice .
Model 105/110/120/125 – Print Current Test Data
1. With the analyzer in its Run Mode, press the
HOLD
button twice to
display the Print Screen.
2. Press
ENTER
to start printing.
Model 105/110/120/125 – Print All Test Data
1. With the analyzer in its Run Mode, press the
HOLD
button twice
to display the Print Screen. Then press the ▲ button to display the
Print All Screen.
2. Press
ENTER
to start printing.