BAC TrilliumSeries DFCV Series, Инструкции по монтажу и установке

Страница: 8 / 32

W W W . B A L T I M O R E A I R C O I L . E U
RIGGING
General notes
1. The equipment arrives on site by truck.
It is recommended to unload the unit with a crane. If the adiabatic pre-cooling sections for the TrilliumSeries are
crated separately, a forklift should be used for unloading of the crate with adiabatic pre-coolers.
A crane must always be used to unload the unit from the truck. Do not attempt to unload the unit using a forklift.
2. Spreader bars of the full width of the section must be used between the lifting cables to prevent damage to the
section.
3. For extended lifts or where hazards exist, it is recommended to use the lifting devices in conjunction with
safety slings placed under the unit.
4. For each unit, only one lift is required. Lifting ears are foreseen on each unit.
5. Attach the lifting devices to the unit as per rigging methods below. Do not use lifting hooks to lift the unit, use
shackles (max. Ø 39 mm) as shown on below picture. Unload the unit from the truck.
Use shackles (max. Ø 39 mm) to lift the unit
6. Install the unit in its final position and anchor to the support beams (supplied by others).
When the unit is installed, all metal parts created by drilling, fastening self tapping screws, grinding, welding or
other mechanical works must be removed from the unit. If they remain on the unit (typically on the double break
flanges) this could lead to corrosion and eventually coating damage.
8
DFCV
DFCV-AD
2
2 Rigging
2 Rigging