WWW.BALTIMOREAIRCOIL.COM
15
PF
i
AND PCC
Optional Accessory Installation
3
Bottom Water Outlet (Optional)
1. The bottom connection seal,
Figure 21
, is typical for all bottom remote sump outlets,
and bypasses. Flange mounting hardware and gasket to be supplied by others.
2. Bottom connection seal kit(s) ship in plastic tubs.
Cold
Water
Basin
Backup
Ring
2 1/4” OD
Gasket
Gasket Provided by Others
Hardware Provided
by Others
Figure 21.
Bottom Water Outlet
PCD Hood Assembly (Optional on PFi Only)
Frame Mounted Assembly: PFi-0406, PFi-0412, PFi-0709, and PFi-0718, (One Fan Only
for PFi-1218, PFi-1236, PFi-2418, and PFi-2436) (
Figure 22
)
1. Verify the mounting frame (and clips for PFi-0406 and PFi-0412) are factory installed
as shown in
Figure 22
.
2. Apply foam tape (BAC part # 270567) to the bottom edge of the PCD hood. Lower
the PCD hood into position by aligning the bolt holes on the PCD hood with the pre-
existing bolt holes on the mounting frame (and clips for PFi-0406 and PFi-0412). Be
sure to follow the minimum height restrictions H found in
Table 3
on
page 16
between
the top of the PCD Hood and the apex of the crane cables supporting the load.
3. Secure the PCD hood using the 5/16” x 1” tappers provided. For PFi-0406 and 0412
units, use the 5/16” x 1” tappers and 3/8” x 1 1/4” bolt provided.
Mounting
Clips
Mounting Frame
PCD Hood
Upper Mechanical
Section
Access Door
Figure 22.
PCD Hood Edge Mounted Assembly (PFi-0406 Shown)
NOTE
: Some parts that ship loose
are labeled with unique three key
codes for identification purposes.
These three key codes are
referenced throughout this guide
to identify parts to be assembled
in the field.
Fan Guard
Clip
