BAC FXVT 288 Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 33 / 44

MOTOR BEARINGS
External motors with frame size >200L (>30kW) have grease fittings
l
grease intervals: twice a year unless otherwise shown on the nameplate of the motor
l
grease products: see below
The bearings should be lubricated only with a hand grease gun. Do not use high pressure grease guns, since they
may rupture the bearing seals. When lubricating, purge the old grease from the bearing by gradually adding grease
until a bead of new grease appears at the seal.
GREASE PRODUCTS
Shell Alvania grease RL3 -20°C to +120°C
Texaco Multifak Premium 3 -30°C to +140°C
Klüber Isoflex LDS Special A -50°C to +120°C
Mobil Mobilith SHC 100 -40°C to +175°C
Total Fina Elf Multis 3 -20°C to +120°C
Grease products
ADJUSTABLE MOTOR BASE (BELT DRIVEN UNITS)
The motor base adjusting screw (see figure below) should be coated every six months using a good quality
corrosion inhibiting grease, such as one of those recommended for lubricating the fan shaft bearings.
Adjustable motor base
1. Motor base slide
2. Adjusting screw
W W W . B A L T I M O R E A I R C O I L . E U
33
5 Maintenance Procedures
5 Maintenance Procedures