BAC FXVT 288 Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 25 / 44

1. Stop fan(s) and pump(s)
2. Loosen the set screw.
3. Using a drift pin centre-punch, tap the collar (in the hole provided) tangentially in the direction of rotation while
holding the shaft.
4. Re-tighten the screw.
5. Close unit access door and start pump(s) and fan(s).
Locking collar assembly
1. Locking collar
2. Lubrication fitting
3. Set screw hole
GEAR DRIVE SYSTEM
Inspection : All gear drives are shipped with oil installed. The initial oil level should be at or near the middle of the
oil level sight gage, and should be maintained so that the oil level is always visible in the sight gage window when
the unit is idle or not energised and the oil is at ambient temperature. Prior to start-up, check all fittings on the gear
drive to ensure that there are no visible leaks. The standard oils provided in BAC gear drive systems are mineral
oils. Synthetic lubricants are also available as an option. Refer to the unit nameplate for the oil type provided with
the gear drive system.
Single reduction gear drive
1. Lubrication fitting
Gear drive units with internally mounted motors are properly installed and aligned at the factory. All fasteners are
factory tightened, but should be checked after installation. For unit supplied with externally mounted motors, install
and align the motor and drive shaft in accordance with the Assembly Instructions included with the unit. It is
recommended that alignment and all external fasteners be rechecked after two weeks of operation.
Operation: No special break-in procedures, other than rechecking alignment and external fasteners, are
necessary.
W W W . B A L T I M O R E A I R C O I L . E U
25
5 Maintenance Procedures
5 Maintenance Procedures