7
USING THE BRAKE
To engage the brake: Press down on the brake lever (located
between each set of rear wheels) with your foot. Check that the brake
is fully engaged on both sets of wheels. If the brake does not engage
fully when applied move the pushchair forwards or backwards slightly
and re apply the brake so that it is fully engaged. To release the
brake, with your foot lift up the brake lever until the wheels move
freely.
NEVER LEAVE THE PUSHCHAIR WITHOUT FIRST ENGAGING
THE BRAKE.
CHECK THE BRAKE IS FULLY ENGAGED BEFORE
LEAVING THE PUSHCHAIR
USING THE SAFETY HARNESS
Always apply the parking brake before placing your child in the
vehicle.
The safety harness has two shoulder straps, a waist belt and
a crotch strap. Place the two shoulder straps over the child
’s
shoulders and the waist belt
around the child’s waist, the crotch strap
should be placed between t
he child’s legs, the waist belt & shoulder
straps should be clipped into the buckle at the end of the crotch strap.
The harness can be adjusted to suit your child by sliding the adjusters
along the shoulder straps and waist belt
.
To release the safety
harness, push the buttons on the centre buckle. D-rings for attaching
a separate harness conforming to BS 6684 can be found attached to
the integral harness at the base of the waist straps.
ALWAYS USE
THE CROTCH STRAP IN COMBINATION WITH THE WAIST BELT.
ALWAYS USE THE SAFETY HARNESS.
FITTING/REMOVING THE HOOD
Clip the hood into position on both sides, the hood clips attach to the
corresponding part near the back of the armrest on the pushchair seat
unit.
FITTING THE APRON (Pushchair)
Fit the apron by attaching the press-studs on the top of the apron to
the corresponding press-studs on the inside of the hood. Use the
elasticated bottom part of the apron to cover the foot rest. The apron
can be fitted either over or under the bumper bar if the bumper bar is
fitted.
Содержание TS2
Страница 2: ...2...
