8
FITTING THE CAR SEAT
Fold the pushchair hood backwards to the open position. Recline the
pushchair seat to the fully reclined position.
Release the fabric that covers the arm rests left and right (attached by
press-studs) and fold the arm rest fabric into the seat base. Unfold
the car seat adaptors by rotating them into the upright position,
ensuring they are fully open. Gently lower the car seat over the
adaptors and push on to the adaptors, the adaptors will click into the
locked position when correctly fitted. Check the car seat is securely
fitted by carefully lifting the car seat away from the pushchair. Raise
the pushchair seat back until it locks in position against the car seat.
REMOVING THE CAR SEAT
To remove the car seat from the pushchair; holding the car seat
handle in the upright position in one hand release the two buttons in
the adaptors (left and right) by pushing in. Slowly lift the car seat away
from the pushchair. Fold the adaptors down and replace the armrest
covers by attaching the press-studs.
ADJUSTING THE SUSPENSION
To adjust the rear wheel suspension, rotate the knob clockwise to the
desired setting. Repeat for both sides. The suspension has two
settings, soft and firm.
NEWBORN LINER
The liner has been designed for use with the Babystyle TS2 pushchair
and should not be used with any other product. The liner creates a
lie-flat environment for your child from birth up to a
maximum of 9kg
THE MAXIMUM WEIGHT OF THE CHILD IN THE NEWBORN
LINER SHOULD NOT EXCEED 9kg
FITTING THE NEWBORN LINER
Open the pushchair and remove the hood.
Recline the seat backrest to the fully reclined position.
Release the press-studs on the fabric armrests and fold the fabric
onto the pushchair seat, the fabric of the arm rests will overlap each
other on the seat base.
Содержание TS2
Страница 2: ...2...
