BabyOno TWINNY, Руководство пользователя

Страница: 4 / 92

4
strength, - to reduce suction strength. Suction strength
can be set between L1 and L9. Each setting offers a
gentle massage and different pumping strength, from
weak to strong.
Select to enter DUAL-FREQUENCY MODE. This is a
creative new pumping experience on both high and
low suction strength settings. The pumping circle
of weak4stop4strong is an effective way to correct
inverted nipples. Touch + to increase suction strength,
- to reduce suction strength. Suction strength can be
set between L1 and L9.
Sleep Mode: The default operating cycle of the main
pump unit is 30 minutes. After 30 minutes, the pump
will turn off automatically.
Screen Lock: When the touch screen is idle for 1 minute,
it will be locked automatically. Press to activate
the touch screen.
When finishing pumping, pour the breast milk from
collection bowl into the nursing bottle and start
nursing or put the breast milk in the a fridge or freezer.
Recommended method: remove the pump unit and
slowly rotate the shell upside down above the bottle
– the milk should flow through the hole.
BATTERY INSTRUCTION
• When the battery is charging, the battery indicator
flashes blue and white.
• When the battery is fully charged, it will turn blue.
A red light indicates low battery, which should be
recharged immediately.
• Take good care of the built-in battery to extend its
lifespan. It is recommended to NOT use the Main Pump
Unit when charging the battery.
• Do NOT remove or change the built-in battery without
professional assistance.
SAFETY GUIDELINES
Do not use the Electric Breast Pump without consulting
your doctor if you have mastitis or inverted or flat nipples.
• The breast pump is personal device. Use by more than one
person may produce a health risk.
• Keep the Electric Breast Pump out of the reach of children.
• Do not use Electric Breast Pump when sleepy or overly
drowsy.
• Do not use the Electric Breast Pump when it is physically
damaged.
• For best results, do not use the Electric Breast Pump with
components of other manufacturers.
• Do not leave the Electric Breast Pump unattended when it
is connected to a source of power supply.
• Do not touch the Electric Breast Pump if it falls in water
and unplug it immediately.
• Do not expose the Electric Breast Pump directly to
sunlight.
• Do not perform any repairs without authorised
professional assistance.
CLEANING AND STERILISATION
• Before using the electric breast pump, disassemble,
wash, and sterilise all parts of the Pumping Kit.
• Partially dry components may have adverse effects
on the operation of your electric breast pump. Please
make sure that all parts are completely dry before use.
GENERAL CLEANING INSTRUCTIONS
Do not wash or sterilise the Main Pump Unit, Power
Adapter, or Charging Cable.
• Clean and sterilize all parts that come into direct
contact with breast milk: Breast Shield, Silicone Insert,
Silicone Gas Storage, Silicone Valve, Collection Bowl.
• Wash the parts in warm water to avoiding milk
contamination and bacteria.
• Do not use solvents or abrasives.
• To clean the electric pump base, wipe the base with a
damp cloth dipped in water or a water and mild soap
solution.
• Suggested sterilisation methods: hot water boiling
for 30 sec, dedicated sterilisers. Do not use microwaves
and washers.
NOTE: Before each use, visually check individual
components for cracks, chips, tears, stains,
discoloration, or deterioration as they may produce
adverse effects in operation. If any damage to the
device is notices, please stop using the device until the
appropriate parts are replaced.
STORING/THAWING BREAST MILK
• Breast milk should be stored and thawed your
correctly. This is the only way to make sure that all