Fig. 1
Fig. 2
To install or replace your trimmer blade set, reverse the procedure, aligning the blade
cushion shaft into the moving blade cushion (see Fig. 2). With the blade held in place,
replace blade screws and tighten loosely. Turn the trimmer over and align the blade set
parallel to the trimmer’s upper housing.
REPLACING (REMOVING) BLADE SET
To remove the FX787G/FX787S/FX787RG blade set, turn the trimmer to the OFF position
and unplug it from the electrical outlet. Turn the trimmer upside down so that the teeth
of the trimmer are facing down. Place the trimmer on a flat surface and using the
screwdriver, loosen the fastening screws from the blade set. Remove the blade set from
Blade screws
Blade set
Screws
Blade cushion
Fixed blade
Moving blade
Screws
Screw holes
BLADE CARE
Because the trimmer blades are precision-made for a very special use, they should
always be handled with care and cleaned regularly to ensure maximum performance.
Each time you finish using the trimmer, take the cleaning brush provided and brush
away any loose hair that has collected in the blades. Use a clean cloth to dry the
attachment, reattach and then store the trimmer to protect the blades until the next use.
Any other servicing should be performed by an authorized service representative, since
the appliance has no other user-serviceable parts. This product is for commercial use.
DO NOT RINSE BLADE OR TRIMMER HANDLE OR ADAPTER.
ZERO GAP ADJUSTMENT TOOL
IMPORTANT!
Only ever attempt to zero gap the blades using the adjustment tool,
following the instructions very precisely.
The adjustment tool is required to adjust the blades to zero gap, to achieve a closer,
more precise cut.
Step 1
– Using the screwdriver included, gently
loosen the two small screws on each side of the
blade.
Step 2
– Slide the zero gap tool over the gold fixed
blade until it is tight against the back portion of the
moving cutting blade.
FX787G(S_RG) IB-16251B.indd 7-8
2019/8/1 4:02 PM
