2. Make sure the switch on the shaver is in the OFF (O) position. Connect
the charging jack into the receptacle on the bottom of the shaver. Plug the
adapter into any electrical outlet (at the voltage listed on the label affixed to
the adaptor). The charging indicator will light up to indicate that the charging
has begun. Charging is complete after 3 hours.
3. The adapter may become warm while charging. This is normal.
4. Preserving the batteries: In order to maintain the optimum capacity of
the rechargeable batteries, the shaver should be recharged for 3 hours
approximately every 6 months.
5. Make sure the switch is in the OFF (O) position when the shaver is not
operating.
FOR DIRECT PLUG-IN OPERATION
Make sure shaver is off. Connect charging jack into the receptacle at the bottom
of shaver and plug the adapter into power outlet.
ON/OFF SWITCH
To operate, simply slide switch to the ON (I) position. To stop operation, set to
the OFF (O) position.
BASIC INSTRUCTIONS FOR USE
1. Men whose skin is sensitive or easily irritated by shaving, or who suffer
from a skin allergy, should test one section on the leg or arm before using
the shaver.
2. Remove the protective cover and turn on the unit to start shaving. Hold the
shaver at a right angle to the area that you want to shave and run the double
shaving foil carefully along your skin. Tip: In general, we recommend that
you shave against the direction of hair growth, as this is the best way to
trim the hair. Pull your skin tight, with your fingers in inaccessible areas, to
achieve optimum results.
3. Switch the shaver off each time after shaving and clean it.
4. Do not push the shaver on the skin too hard as it could cause irritation, make
the shaver warm and prevent a perfect shave.
5. Please note that it takes 2 to 4 weeks for your skin to adapt to a shaver, so
please do not change shaving instruments in this period of time.
6. If hair is longer than 1/32” begin by cutting the hair down first with a trimmer,
than use shaver for a smooth close shave.
USER MAINTENANCE
INSTRUCTIONS
TAKING CARE OF YOUR SHAVER
Do not remove the shaving foil unit while the shaver is switched on. Always
switch the shaver off!
Ensure that no water gets into the inside of the shaver to avoid the risk of an
electric shock when it is back in operation.
Never press on the cutting blades or the shaving foil and do not touch them
with hard objects as this can cause irreparable damage to the shaver or parts.
Be careful when dealing with the blades, as they are very sharp. Risk of injury!
When cleaning, do not apply any detergents or scouring agents and do not use
any abrasive or sharp objects. They can cause irreparable damage to the shaver.
VERY IMPORTANT: Cutters must be cleaned and oiled on a regular basis
for proper functioning. Failure to regularly clean and oil the cutters will
void the warranty.
BFS2DBR & BRF2G IB-18_285A.indd 5-6
10/29/19 4:17 PM
