14
15
2. Move the babybay next to the bed. Make sure the top of the safety barrier
is below the top of the parent’s mattress and adjust the sleeping platform
height as needed. Place the metal arms over the bed frame. Adjust the
length of the arms so the babybay is snug against the bed frame and firmly
tighten the wingnuts so the arms will not move. Then firmly tighten the
clamps. Adjust as needed.
Fixing Set: Attaching to Bottom of Bed Frame
1. Use the Allen wrench to remove the screw on the side of each fixing set,
position the metal arms facing down. Reattach the clamps to the fixing sets
making sure to leave the screws a little loose.
2. Move the babybay next to the bed. Make sure the top of the safety barrier
is below the top of the parent’s mattress and adjust the sleeping platform
height as needed. Place the metal arms under the bed frame and adjust the
height of the fixing set up as much as the bed frame allows. Then adjust the
length of the arms so the babybay is snug against the bed frame and firmly
tighten the wingnuts so the arms will not move. Then firmly tighten the
clamps. Adjust as needed.
Resistance Plate: Attaching to Bed Frame
NOTE: The safety barrier must be below the top of parent’s mattress.
1. Move the babybay next to the bed. Make sure the top of the safety barrier
is below the top of the parent’s mattress and adjust the sleeping platform
height as needed.
2. Unroll the straps from the resistance plate and lay them across the parent’s
bed. With the resistance plate on the parent’s bed opposite to the babybay,
use a sawing motion to slide the straps between the mattress and the
boxspring. Use this sawing motion to move the resistance plate directly
across from the babybay’s desired location. Connect the buckles to the front
two rail rods on each side of the babybay.
3. Tighten the attachment straps at the strap loops protruding out of the
resistance plate on the other side of the parent bed by pulling so that the
babybay is pulled tight against the parent’s bed. Check tightness of the
attachment straps each time you place the baby into the babybay so that there
is never a gap between the parent’s bed and babybay.