Babyauto Biro 01, Инструкция по эксплуатации

Страница: 16 / 28

16
3. installinG tHe car seat. GrouP 0+
GROUP 0+ only. 0 to 10 months
(0-10 Kg)
notice
1. Check the seat is ready to be installed rearward facing (Group
0) as shown in fig. 3.1. Recline the seat fully. Pull the lever
(g)
forward and adjust the angle of recline to position 4 without
releasing the lever. If it is necessary swivel the seat 180º to place
the seat in the opposite direction of travel (fig. 3.1.A). Release
the lever when the seat is in the desired position (fig. 3.1)
2. Place the seat in the back seat of the vehicle and contrary to
the direction of travel (fig. 3.2).
3. Pass the abdominal strap of the seat belt through the lower
seat guides
(K)
(fig.3.3) and underneath the seat. Buckle the
vehicle seat belt until you hear a click (fig. 3.5).
2. VeHicle installation Points
WHERE:
In the vehicle rear seats.
2
1
HOW:
GROUP 0+ / Install rearward facing.
GROUP 1 / Install forward facing.
NOTICE:
The child seat must only be used in this seat IF it has a lap and
diagonal belt (3 points).
Please, do NOT install the safety seat in forward seats except for
the following cases:
1. Whenever the vehicle does not count with rear seats.
2. When all rear seats are already occupied by children
exceeding 135 cm height.
3. When it is not possible to install all child restraints systems in
the rear seats.