51
52
Copyright © 2021, Baby Trend, Inc.
Copyright © 2021, Baby Trend, Inc.
3. Unbuckle Harness Buckle by pressing
button and sliding buckle tongues up and
out of buckle. (Fig 51-1)
4. Place your child in the Car Seat so that
the child’s bottom is against the back and
bottom of the seat. (Fig 51-2)
5. Check that the harness straps are located at
the proper height for your child. The proper
height of the harness straps is at or just below
your child’s shoulders. (Fig 51-3) (see Section
11.2 Adjusting Harness Strap Height)
6. Place harness straps over child’s shoulders
and put the two buckle tongues together,
overlaying the left buckle tongue onto the
right buckle tongue, and insert the two
joined buckle tongues into the harness
buckle until they click into place.
Note: Pull up on tongues to make sure that
BOTH tongues click into place. (Fig 51-4)
7. Check buckle height - The Crotch
Strap should be adjusted so that
a gap of 12.5 mm to 25 mm (1/2”
to 1”) is present between the ears
of the buckle and the top of child’s
thigh (Fig 52-1), disregarding any
clothing or diaper. If buckle is too
low or to high, adjust height. (See
Section 11.3 Adjusting Crotch
Strap Length)
8. Check that the straps are not twisted and
lie flat over the shoulders.
9. Tighten the harness straps to snugly
adjust harness around child by pulling
the Harness Adjuster Strap at the front of
the Car Seat as shown. (Fig 52-2)
10. Connect the Harness Clip and position
the Harness Clip at the middle of the
child’s chest, level with the armpits.
12. Check Harness Straps - Make sure the straps are flat and snug
against the child’s shoulders and thighs.
NOTE: A snug strap should not allow any slack. It lies in a
relatively straight line without sagging. It does not press on the
child’s flesh or push the child’s body into an unnatural position.
51-1
Press
50-2
Correct
Incorrect
51-3
51-4
52-2
52-1
thigh
buckle
11.0 Harness System Use and Adjustment
11.0 Harness System Use and Adjustment
