Baby Trend JG50, Инструкция по эксплуатации

Страница: 8 / 26

14
MAINTENANCE
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
13
INFANT CAR SEAT
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
INFANT CAR SEAT
WARNING:
Never
jog or run with your newborn
in the car seat position. Use
for strolling only.
WARNING:
Avoid
serious injury from falling or
sliding out, always use the
Infant Car Seat harness.
•
ONLY
approved Snap Tech™ products can be
used on the frame.
21)
• Attach the car seat by lining up the seat
anchors on the side of the car seat
with the anchors on the stroller frame
and push them together until they lock
securely (Fig. 21).
TO REMOVE THE INFANT
CAR SEAT OR SEAT
22) • To take off the seat or the infant car
seat, push both center buttons on
each side of the seat and lift the seat
upwards (Fig. 22a).
NOTE: For the stroller seat only:
DO NOT remove with child in the
stroller seat (Fig 22b) .
TESTING FOR PROPER WHEEL INSTALLATION
WARNING:
ALWAYS check the double nut
locking system before each use to ensure that the front
wheel is securely fastened to the frame.
Fig. 23
Fig. 24
Fig. 25b
Fig. 25a
23) • Lift the front wheel off of the ground and
sharply strike the top of the tire (Fig. 23).
The wheel should not be loose or come off.
If you experience front wheel wobble that is beyond
what is normal for use while walking or jogging you
may have to adjust the front wheel housing nut.
24)
• Remove footrest to access nut. You can
use a standard crescent wrench to tighten
the nut (Fig. 24).
DO NOT OVER TIGHTEN this can cause
damage to the wheel housing.
FENDER
If adjustment or replacement is necessary:
25)
• Line up the front fender and press onto the
front frame assembly (Fig. 25a).
• Insert the 4 screws through the underside
of the front frame assembly into the front
fender’s plastic tubes. Tighten the screws
only until snug (Fig. 25b).
DO NOT OVER TIGHTEN.
SEAT PAD
• To clean the seat pad, use only mild
household soap or detergent and warm
water on a sponge or clean cloth.
OTHER
• Check your stroller for loose screws, worn
parts, torn material or stitching on a regular
basis. Replace or repair parts as needed.
Fig. 21
Fig. 22a
Fig. 22b