• Lean the stroller forward to rest on the front wheel. To attach the rear
wheels, push each wheel's axle into the plastic corner fitting as shown in
figure 8. Lift upward on the plastic lever on the inside of the corner fitting
as you push the axle into corner fitting. When the wheel will not go on
any farther, release the lever. Check that the wheel has locked into the
corner fitting by pulling on the wheel. If not locked, lift upward on the
lever, push the wheel on farther and release lever.
Ensure that the wheels are firmly locked into place. Do Not use the stroller
if the wheels are not locked into place, but rather contact our customer
service department immediately at (800) 328-7363, between the hours of
8:00am and 4:30pm PCT, for assistance
• To attach the parent tray, align the fittings on the ends of the parent tray
with the fittings on the outsides of the handle. Hook one end of the tray
on so that the fitting on the handle protrudes from the hole in the parent
tray. Pull outward on the opposite end while pushing down on the tray
until locked onto the stroller handle. Please be careful not to pinch your
fingers when installing the parent tray. Please see figure 9C. To remove
the parent tray, pull outward on one end of the tray while lifting upward.
WARNING:
Do not place hot liquids
or more than 3 pounds in the parent tray.
Serious burns or unstable conditions could
result.
•
To open the canopy, push forward on the front edge of the canopy while
holding the rear of canopy in place. Please see figure 10.
•
To fold the canopy, pull backwards on the front edge. Please see figure
11.
The canopy must be in the closed position before folding the stroller.
Your stroller is now ready to use
Figure 4.
Figure 5.
Figure 6.
Figure 7a.
Figure 7b.
4
Figure 10.
Figure 11.
Figure 8.
Figure 9.
Open
Close
Open
