Baby Trend CV88D, Руководство пользователя

Страница: 24 / 29

45 46
Copyright © 2018, Baby Trend, Inc. Copyright © 2018, Baby Trend, Inc.
A.2 Feed one Harness Strap Connector plate through each Harness
Strap End (1) . Ensure both Straps are securely connected to the
connector plate (2) .
- Only splitter plates with “Single Use Approved BT 2016” are
approved for single use.
- Inspect the Harness Straps from the front and back of the car
seat to ensure that they are not twisted. Twisted harness straps
can prevent proper tightening of the harness and thus may
not adequately restrain your child in a sharp turn, sudden stop
or crash. Before Using the car sat, please pull on the harness
straps from the front of the car seat to ensure they are securely
re-attached.
SI
NG
LE U
SE A
PP
RO VE
D
BT
20
16
SIN
GLE
US E A
PPR
OV
ED
B
T 2
016
SINGLE
USE A PPROV
ED
B
T 2016
SIN G
LE
U SE
A
PP RO
VE
D
B
T 2
01
6
SIN
G
LE
U
SE
A
PP
RO
VE
D
B
T 2
01
6
1 inch (2.54 cm)
5.14 Locking Clip Use
1. If your vehicle lap/shoulder belt requires the
use of a Locking Clip to prevent the belt from
oosening after installation, thread the locking clip on the belt as
close to the latch plate as possible – within 1 inch (2.54 cm).
5.0 Installation and Use
1. Removal: Remove the upper seat back by
lifting the release tab and pulling up on the
upper seat back.
NOTE: DO NOT store the upper seat back in
the passenger compartment. Store the upper
seat back in a secure location like your trunk
or garage.
2. Installation: Align the upper seat back rods
and push rods into the openings until you
hear the seat back lock into place. Pull up on
the upper seat back to ensure the removable
upper seat back is locked in position.
The upper seat back must be installed: When the
child weighs more than 22 lbs (9.98 kg) or Top of
head has reached max height red line on seat back
or The restraint is forward facing.
WARNING
Click
5.15 Upper Seat Back Removal and Installation
5.0 Installation and Use