Baby Trend CV88D, Руководство пользователя

Страница: 22 / 29

41 42
Copyright © 2018, Baby Trend, Inc. Copyright © 2018, Baby Trend, Inc.
2. Rear Facing - Harness Strap should be located
in the nearest position at or below the shoulder
(Fig. 42a).
Forward Facing - Harness Strap Height should
be located in the slot at or slightly above the
child’s shoulder (Fig. 42b).
NOTE: Forward facing occupants weighing
more than 32 lbs (14.5kg) or are 35 in. tall
(88.9 cm) MUST use height position 4.
Then place harness straps over the child’s
shoulders (Fig. 42c).
NOTE: Check the height of the harness straps
are just above the child’s shoulders.
3. The Convertible has been safety tested with the
height insert and head pillow (Fig. 42d) that are
included with this restraint. The height insert is
needed until the child’s shoulder is at or above
position 1. Do not use height insert or pillow with
a child weighing more than 18 lbs.
4. Insert the buckle tongues into the buckle
(Fig. 42e).
NOTE: Pull up and test buckle tongues to be
sure they are secure.
5. Place chest clip at arm pit level (Fig. 42f). Insert
chest clip tabs and press together. Pull outward on
chest clip’s ends to be sure it is secure.
5.10 Child Placement in Restraint
1. Place child in the restraint with the child’s
back flat against the back of the restraint and
the child’s bottom touching the seat (Fig 41c).
Fig. 42c
Fig. 42a
Fig. 42b
Fig. 42d
10. Raise Forward Lock-off over the LATCH
belt. Engage the lock tab and press down to
lock (Fig. 41a).
11. Lower flap and secure hook and loop
fasteners (Fig. 41b).
5.9 Aircraft installation
1. Follow the vehicle lap belt
installation for use in an Aircraft.
2. Consult your airline for requirements to use
this restraint.
Fig. 41b
Fig. 41c
Fig. 41a
Fig. 42e
Fig. 42f
5.0 Installation and Use 5.0 Installation and Use