MAKING EMBROIDERY ADJUSTMENTS
95
Ad
va
nc
ed
Ed
iti
n
g
3
■
Bobbin Thread is Too Tight
Upper thread on the right side of fabric seems to be
lifting/looping and bobbin thread is not seen on the
wrong side of fabric.
a
Right side
b
Wrong side
*
Light gray color represents upper thread.
*
Dark gray color represents bobbin thread.
If this occurs, turn the slotted screw (-)
counterclockwise, being careful not to over-loosen
the screw, approximately 30-45 degrees to decrease
bobbin tension.
Using the Automatic Thread
Cutting Function (End Color
Trim)
The automatic thread cutting function
will
cut the thread at the end of embroidering each
color. This function is initially turned ON. To turn
this function OFF, touch
key and then
.
*
This setting returns to its default
when the
machine is turned off.
a
Touch .
b
Touch
to turn off the automatic
thread cutting function.
The key will display as
. When one color
thread is embroidered, the machine will stop
without cutting the thread.
IMPORTANT
• DO NOT adjust the position of the phillips (+)
screw on the alternate bobbin case as this may
result in damage to the bobbin case, rendering
it unusable.
• If the slotted screw (-) is difficult to turn, do
not use force. Turning the screw too much or
providing force in either (rotational) direction
may cause damage to the bobbin case. Should
damage occur, the bobbin case may not
maintain proper tension.
Note
• When adjusting the alternate bobbin case, be
sure to remove the bobbin from the alternate
bobbin case.
Содержание Solaris VISION BLSA3
