Fig. 10-1-C
Fig. 10-2-C
Rail Ratcheting End
Non-Ratcheting End Insert
Idler Rail Clamp Locking Assembly
Idler Clamp Floating Insert
M6 Set Screws
Fig. 11-1-a
Fig. 11-1-b
Fig. 11-2
Hinge
Hinge
Page. 13
Parts Needed:
4- Rail Ratcheting End
4- Rail Non-Ratcheting End
1- Idler Rail Clamp Locking
Assembly
1- Idler Clamp Floating Assembly
8 - M6 x 10mm Set Screws (Pre-
installed in the Rail Couplers)
Tools Required:
3mm Allen Wrench
4mm Allen Wrench
6mm Allen Wrench
10-1-C:
Unfasten the Non-Ratcheting End Insert from a Rail Non-Ratcheting End with a 6mm Allen Wrench.
Insert and fasten the Non-Ratcheting End Insert into the Rail Ratcheting End. (Fig. 10-1-C)
Note:
If the rail end is difficult to remove, loosen the bolt half way out. Push in the bolt to release the com
-
pression cone, which will allow the rail end to be easily removed.
10-2-C: Repeat step 10-1-C for the remaining 3 rail ends.
10-3-C:
Unfasten the Idler Clamp Floating Insert from the Idler Clamp Floating Assembly by removing four
M6 Set Screws with an M3 Allen Wrench. Insert and Fasten the Idler Clamp Floating Insert into the Idler Rail
Clamp Locking Assembly. Align the Clamp Rails so that the hinges are on the same side. (Fig. 10-2-C)
Step: 10-C: Rail Assembly for Crib
Parts Needed:
1- Magnet Bracket
1- Magnet Bracket Spacer
1- 1/4 x 1 inch Hex Bolt
Tools Required:
1- 7/16 inch Wrench (Not provided with frame
contents.)
11-1-a:
To install Precision Glide Wheels, remove the
hex bolt from the rear right machine wheel. Align and
fasten the Magnet Bracket Spacer and re-attach the hex
bolt. (Fig. 11-1-a)
11-1-b:
When using Standard Wheels, remove the
hex bolt from the rear right machine wheel. Align and
fasten the Magnet Bracket Spacer, Magnet Bracket, and
1/4 x 1 inch Hex Bolt provided with the hardware. (Fig.
11-1-b)
11-2: Place the Machine on the Bottom Carriage.
(Fig. 9-3)
Step 11: Machine Magnetic Bracket
Precision Glide Wheels
Magnet Bracket Spacer
Magnet Bracket
1/4 inch Hex Bolt (included)
Содержание Momentum BLQM
Страница 1: ......
