Fig. 5-1-C
M6 Connector Bolt
M6 Plastic Washer
Fig. 5-2-C
Front Rail Bracket Left Rail Holder End
Front Rail Bracket Right Ratchet End
M8 Nylock Nut
M8 x 50mm SBHCS
Fig. 6-2
Rail Holding End
Ratchet End
Back Track Assembly Side
Plastic Track
Back Track Support
Front Track Support
Front Rail Bracket Left Rail Holder
End
M8 x 16mm SBHCS
Fig. 6-1
Page. 9
Parts Needed:
4- 5 ft Plastic Track
Tools Required:
4mm Allen Wrench
5-1-C:
Detach the pre-installed Track Support
from the Table Assembly by unfastening the
M6 Connector Bolts with a 4mm Allen Wrench.
(Fig. 5-1-C)
5-2-C: Slide the 5 ft Plastic Track down the
track grooves of the Track Support Assembly.
(Fig. 5-2-C)
5-3-C: Repeat step 5-2 to assemble the 5 ft
Front Track Support Assembly.
5-4-C: Loosely fasten the Front Track Assem-
bly and securely fasten the Back Track Assem-
bly onto the Table Assembly with Connector
Bolts and M6 Plastic Washer. The Rear Track
Assembly side should be flush with the back
edge of the table. (Fig. 5-1)
Note: The Front Track Assembly will be ad-
justed and tightened in step 9.
Parts Needed:
1- Front Rail Bracket Right Ratchet End
1- Front Rail Bracket Left Rail Holder End
4- M8 x 50mm SBHCS
4- M8 Nylock Nut
Tools Required:
5mm Allen Wrench
Open Wrench 13mm and 10mm
Note: The bolt height may need to be adjusted after the
sewing machine has been set on the frame so that fabric
lays flat in the throat of the machine. This assembly step
is universal for both Crib and King size frames.
6-1: Insert the Rail Brackets into the corresponding tube
ends. (Fig. 6-2)
Note:
Loosen the M8 x 16mm SBHCS on the Rail Brack
-
ets if the brackets are a tight fit into frame ends.
Step 5-C: Track Assembly for Crib Size Frame
Step 6: Front Rail Bracket Assembly
Содержание Momentum BLQM
Страница 1: ......
