Baby Lock BLE1EX, Инструкция и справочник

Страница: 39 / 50

U L U L
U L
U L
U L U L
U L
U L U L
U L
U L
U L U L
U L
U L U L
U L
U L
U L U L
U L
U L U L
U L
U L
U L U L
U L
U L U L
U L
U L
U L U L
U L
U L U L
U L
U L
U L U L
U L
U L U L
U L
U L
U L U L
U L
Thread Cradle for Loopers
1. Open the front cover and raise the presser foot.
2. At the threading port, clip the looper thread that is to be re-
placed. (fig. A) Remove thread from under the foot and the
upper thread guides. Replace cone of thread with specialty
thread.
3. With machine in locked position (fig. B-C) set the looper
threading port to U or L, according to the looper that is be-
ing threaded.
4. Thread specialty thread into the upper thread guides, leav-
ing an 18 inch (45cm) tail above the threading port. (fig. D)
5. Cut a 24 inch (55cm) strand of serger thread and fold in half
to form a thread cradle. Insert the loose ends of the thread
cradle into the port about 1 inch (2,5cm).
6. Holding the cradle loop with left hand, depress the thread-
ing lever with your right hand (fig. E) until the thread ends
come out the looper eye.
7. Insert the specialty thread tail into the cradle loop (fig. F),
pull the serger thread ends until the specialty thread comes
through the looper eye. (fig. G) Discard or set aside the
thread cradle.
8. Run upper looper thread under the foot and to the left, cut
lower looper thread to 4 inches (10cm) and leave it hanging
loose.
37
U
S
I
N
G
S
P
E
C
I
A
L
T
Y
T
H
R
E
A
D
S
A A
B B
C C
D D
E E
G G FF