B9Creations B9Clean, Руководство пользователя, Страница: 16 / 25

7.5 Configuring the cleaning cycle settings
The Start/Stop button (A) starts or stops a cleaning cycle and is
located on the right side of the control interface. A cleaning cycle
is characterized by the 3D printed parts in the inner container
being submerged in isopropyl alcohol that is stirred at a specified
speed for a specified duration.
The duration of the cleaning cycle is measured in minutes and
controlled by the top set of buttons and indicator lights (B) on
the left side of the control interface.
The speed at which the isopropyl alcohol is stirred is controlled
by the bottom set of buttons and indicator lights (C) on the left
side of the control interface.
Use the buttons on either side of the duration and speed
indicator lights to configure the cleaning cycle settings as desired.
7.6 Overview of starting, stopping or adjusting the cleaning
cycle.
Before starting the cleaning cycle, ensure the following
conditions are met.
The outer container, inner container, inner container plug,
hanging arm, Build Table, and lid are all secured in their proper
positions.
The isopropyl alcohol fill level, inner container plug, and hanging
arm are correct for the height of the 3D printed parts to be
cleaned.
The magnetic stirring bar is placed in the bottom of the inner
container.
The part tray is inside the inner container only if any one of the
3D printed parts to be cleaned is not attached to the Build Table.
The control interface’s indicator lights show the desired settings.
Press the Start/Stop button to begin the cleaning cycle. The
cleaning cycle will run using the duration and spin speed set on
the control interface, reversing the direction of the spin every
minute. Cleaning process timer count down and stirrer operation
starts after filling of internal container.
To alter the duration or spin speed while the cleaning cycle is in
progress, change the desired settings on the control interface.
A
B
C