B9Creations B9Clean, Руководство пользователя

Страница: 14 / 25

7.2 Filling with isopropyl alcohol
Place the outer container in the base and remove the lid and inner container.
Isopropyl alcohol is stored solely in the outer container. Do not manually fill the inner container with
isopropyl alcohol. The unit will regulate when the inner container is filled during the cleaning cycle.
The amount of isopropyl alcohol that shall be loaded in the outer container is dependent on the 3D printed
parts to be cleaned during the next cleaning cycle. The outer container has two fill lines that correspond to
two possible volumes: 1.3 liters and 2.0 liters.
If the height of the parts to be cleaned is less than
70 millimeters, fill the outer container to the
1.3-liter fill line.
If the height of the parts to be cleaned is 70 millimeters or greater, fill the outer container to the 2.0-liter
fill line.
CAUTION
Take care to ensure that no isopropyl alcohol spills from the outer container at any time. Stray isopropyl
alcohol may damage the B9Clean’s electronics or surrounding materials.
FLAMMABLE
Isopropyl alcohol is highly flammable in both liquid and vapor states.
Read the safety information in Section 2.5 before handling isopropyl alcohol.
CAUTION
Failure to load the outer container with the correct amount of isopropyl alcohol based on 3D printed
part height can result in damage to the cleaned parts.
If not enough isopropyl alcohol is loaded, the parts will not be fully submerged and the top of part will not
be cleaned.
If too much isopropyl alcohol is loaded, the inner container will not completely drain of isopropyl alcohol
when the cleaning cycle ends. The 3D printed parts may then be left to soak in the undrained isopropyl
alcohol, potentially weakening the cured resin of the parts.
NOTE
The isopropyl alcohol in the outer container can be used for multiple cleaning cycles, but the cleansing
effectiveness of a reused batch of isopropyl alcohol may decrease with each cleaning cycle it is used
depending upon material used and part geometry. Refill the isopropyl alcohol before the cleaning result
is no longer sufficient.
Note
Never install both drain plugs during operation.