5
CAUTION
Panel layout
sld5k
GND (GROUND CONNECTION)
+ 12V (POWER CONNECTION)
Connects to the vehicle’s chassis.
Connects to the positive terminal of the battery.
Keep as short as possible (< 20” / 50 cm)
For specified performance 0 Ga cable is required.
Use minimum 0 Ga cable for optimal conditions.
Fuses shall be placed within 8” / 20 cm of the battery.
The HI-EF class D design allows for higher output
REM (REMOTE)
power, even at low voltage applications.
Connects to sw12V from the headunit.
This sets high requirements to the battery system.
Choose
batteries
with
high
CCA
ratio.
speaker (speaker output)
Connects to the speaker(s) leads. Ensure polarity is correct
on the speaker and connect to the corresponding
output. NOTE, terminal is internally bridged and minimum
impedance is 1 ohm.
In STRAPPED mode, minimum load is 2 ohm.
Use high quality cable of at least 12 Ga.
Installation of the amplifier shall be done in the following steps:
1. Connect the +12V wire, keep in mind this wire has to be fused at the battery as well. 2. Ensure the ground is
appropriate, then connect it to the amplifier. 3. Connect the switched remote. 4. Reattach negative wire (ground)
to the battery. 5. Operation over 18 V will cause the amplifier to go into protect & can void the warranty!
BATTERY
Head unit
* Keep ground as short as possible, no longer
than 20” (50 cm).
500A (External fuse)
POWER
POWER
GND
B+
B+
REM
GND
GROUND*