B.Well WA-88, Инструкция по эксплуатации

Страница: 14 / 36

12
Further information
Measurements should not occur soon after each other, since otherwise, the results will be falsified. Wait
therefore for several minutes in a relaxed position, sitting or lying, before you repeat a measurement.
6. Error messages/malfunctions 6. Error messages/malfunctions
If an error occurs during a measurement, the measurement is discontinued and a corresponding error
code is displayed (Example: Error No. 2).
Error No. Possible cause(s)
«Err 1» No pulse has been detected.
«Err 2» Unnatural pressure impulses influence the measurement result. Reason: The arm was
moved during the Measurement (Artefact).
«Err 3» The inflation of the cuff takes too long. The cuff is not correctly seated.
Other possible malfunctions and their elimination
If problems occur when using the device, the following points should be checked and if necessary, the
corresponding measures are to be taken:
Malfunction Remedy
The display remains empty when the instrument is
switched on although the batteries are in place. 1. Check batteries for correct polarity and if
necessary insert correctly.
2. If the display is unusual, re-insert batteries
or exchange them.
The device frequently fails to measure the blood
pressure values, or the values measured are too
low (too high). 1. Check the positioning of the cuff.
2. Measure the blood-pres sure again in pe-
ace and quiet under observance of the details
made under point 5.
Every measurement results in different values, alth-
ough the device functions normally and
normal values are displayed. 1. Please pay attention to the following in-
formation as well as the points listed under
«Common sources of error» and repeat the
measurement.
The blood pressure values measured differ from
those measured by the doctor. 1. Record the daily development of the val ues
and consult your doctor about them.
istruction_All.indd 12 13.04.2006 16:06:54