B.Pro B.PROTHERM BPT 1020 EUK, Перевод оригинальной инструкции по эксплуатации

Страница: 19 / 48

B.PROTHERM Stainless-Steel, Cooled
– 15 –

If defrosting is unsuccessful, refrigeration must be interrupted for a longer
time. The procedure to follow in this case is described below:

Unplug the power plug and insert it into the power plug retainer.

Chapter "Shutting down" on Page 22.
– or –
Press the "Refrigeration ON/OFF" button.
The unit switches into standby mode. The temperature display will now
show
AUS
(OFF).

Leave cooling switched off for 24 hours .

The condensation-water catch tray must be emptied several times
depending on the amount of condensation water produced.

Clean the unit.

Subsection "Cleaning the unit" on Page 27.
Acknowledging temperature
alarm

After cooling is activated or the unit door is closed, no temperature over-
shoot or undershoot of the setpoint is detected for 60 minutes to prevent
an alarm indication from arising during the pre-cooling phase.

If the actual temperature deviates from the setpoint by a certain amount
(
±
7 °C), this temperature overshoot/undershoot is registered by the tem-
perature regulator. The temperature display begins to flash (visual alarm)
if the actual temperature is outside the specified temperature range
(
±
7 °C) around the setpoint for longer than 60 minutes.

Acknowledge the temperature alarm with the "DOWN" button.

Clarify the cause of the temperature alarm, e.g. icing-up of the evapora-
tor.

Chapter "Help in the event of problems" on Page 23.

Initiate suitable measures, e.g. defrosting.

Chapter "Help in the event of problems" on Page 23.
The temperature display stops flashing after a permissible temperature
value is reached.
Pre-cooling the unit

To prevent foodstuffs in the unit from being warmed up, the unit must be
precooled for a maximum of 30 minutes depending on the selected set-
point temperature and on the ambient temperature.

Condensation-water catch tray pushed in under the unit as far as the
stop

Unit door closed

Approx. 30 minutes before putting food in, plug the power plug into the
electrical outlet.

If the unit is in standby mode (
OFF
appears in the temperature display),
start refrigeration by pressing the "Refrigeration ON/OFF" button.
The temperature display will now show the current temperature in the unit
interior.
The unit interior will now be cooled down.
As soon as the set setpoint temperature is reached, the cooling unit
switches off and the operation indicator LED "Refrigeration unit" goes
out. The fan remains in operation.