HP
2
/ CO
2
SERIES
Solid State LED
Relamping and Optic Replacement
TECHNOLOGY
with
Warning
Hot Surface
TOOLS
NEEDED:
By Others
1/8” Allen Wrench
Phillips Screwdriver
Small Flat Head Screwdriver
Relamping and/or Optic Replacement if Required for Solid State LED
RELEASED
7-13-16
REFERENCE
NUMBER
INS000012
%ULFN\DUG
'ULYH
0DGHUD
&$
86$
)$;
ZZZENOLJKWLQJFRP
LQIR#ENOLJKWLQJFRP
B-K LIGHTING
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF B-K LIGHTING, INC. AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR SELL ANYTHING IT MAY
DESCRIBE. REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF B-K LIGHTING, INC. IS STRICTLY FORBIDDEN.
IMPORTANT SAFETY INFORMATION - READ, FOLLOW, AND SAVE THESE INSTALLATION INSTRUCTIONS
10. Install faceplate using 1/8” Allen wrench and hand-
tighten the faceplate screws in a star pattern to 30
in-lbs. min.
Do not use a power tool to install screws. Do not
exceed 40 in-lbs.
1. Remove faceplate using 1/8” Allen wrench.
9. Remove any dirt or debris in O-ring groove near top
of housing. Place O-Ring inside of groove. Clean
lens if needed.
Failure to clean groove of debris will cause fixture
to fail and void product warranty.
3. Use 5/64” Allen wrench to remove two (2) #2-56
screws on LED board. Grasp LED board gently and
expose quick disconnect. Disengage LED board from
driver assembly.
2. Space three fingers evenly around the optic and
gently rock optic to remove.
4. Use Phillips screwdriver to loosen #8-32 Phillips
screw on driver bracket on OptiLock®. Disconnect
driver from fixture via quick disconnect. Replace
old driver. Place new driver in bracket, then
tighten #8-32 Phillips screw to secure new driver to
OptiLock®. Reconnect new replacement driver to
fixture and to LED board via quick disconnects.
6.
If OptiLock® Has Thumbscrew Aim:
Aim vertically by
turning the thumbscrew on OptiLock® assembly.
7.
If OptiLock® Has Tilt Assembly Aim:
Aim vertically
by turning the #10 Phillips head screw on OptiLock®
assembly with Phillips screwdriver.
5. Secure LED board to heatsink by tightening two (2)
#2-56 screws on LED board using 5/64” Allen wrench.
Carefully snap optics back into tabs on LED board.
8. With flat head screw driver rotate Adjust-e-Lume®
dial to desired lumen output.
