RELEASE DATE
08/16/2022
REFERENCE NUMBER
INS-2873-00
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
Integral Driver Replacement
3. Disengage the heatsink by tightening the two
(2) #8-32 flat head screws by using a 3/32”
allen wrench. Rotate the heatsink to align the
screws with slots to remove.
2. Twist and pull away optic.
1. Loosen three (3) #8-32 set screws on the cap
by using a 5/64” allen wrench. Do not remove
set screws. firmly pull on the cap to remove.
7. Reconnect heatsink assembly to driver
assembly via quick disconnect. Quick
disconnect tucks into space underneath
heatsink.
4. Lift lever on the wago connector to remove
LED leads.
5. Separate heatsink from driver assembly via
quick disconnect.
6. Remove driver from fixture via quick
disconnect. Replace with the new driver and
reinstall into fixture.
10. Install the cap on by tightening three (3) #8-32
set screws by using a 5/64” allen wrench.
Do not over tighten. Cap should be able to
rotate without force.
9. Twist to reinstall optic onto optic holder.
8. Align the flat head screws with slots in the
fixture and reinstall the heatsink back on.
Rotate the heatsink into place and loosen the
two (2) #8-32 flat head screws using a 3/32”
allen wrench to engage heatsink.
HUME
UPLIGHT - INTEGRAL
Standard Installation
