1.
Installing the Saddle Valve (diagram 1)
Use of a hand drill is recommended. To protect
yourself from serious injury or fatal shock when
using an electric drill, be sure the drill and the out-
let it is plugged into are properly grounded. When
using a drill, follow the manufacturer’s guidelines
and procedures.
note: Saddle valve must be installed on a 51 mm
(2-inch) long, straight-walled section of 10-22 mm
(3/8-inch to 7/8-inch) steel, brass, copper, or
PVC pipe.
(a)
Turn off cold water supply and turn on nearest
faucet before starting installation. Place a tray or
towels under the cold water line to catch excess
water.
(B)
Drill a 3 mm (1/8-inch) hole in cold water line.
Remove any burrs with sandpaper or file.
(c)
Turn handle on the saddle valve to expose
lance no more than 5 mm (3/16-inch) beyond
black rubber gasket.
(D)
Place valve body over hole in cold water line
so lance fits into hole.
(e)
Attach back plate of clamp and tighten bolts
evenly and firmly so brackets are parallel.
(f)
Turn valve handle clockwise to closed position
and leave closed until installation is complete.
2.
Selecting the Faucet Location (diagram 2)
note: The drinking water faucet should be posi-
tioned with function, convenience, and appear-
ance in mind. An adequate flat area is required
to allow faucet base to rest securely. The faucet
fits through a 19mm (3/4-inch) hole. Most sinks
have pre-drilled 35 or 38mm (1-inch) diameter
holes that may be used for faucet. If installation of
these pre-drilled holes cannot be used or are in an
inconvenient location, it will be necessary to drill a
19mm (3/4-inch) hole in the sink to accommodate
the faucet.
9333
Nanotechnology Under Counter Water Purification System
3
Hel neu st 57
i n S ta L L at i o n
•
For standard under-sink installation on 10 mm (3/8-inch) cold water line.
•
Please read all instructions and precautions before installing and using your filtration System.
•
Numbered diagrams correspond with numbered steps.
