B+BTec KARAT 180 BG, Перевод оригинальной инструкции

Страница: 21 / 36

KARAT ® 180 GB
OPERATING MANUAL KARAT® 180
21
DRILLING WITH A DRILL
STAND
Guide block setting
A
B
When using a drill stand a right setting of the
guide block is required. Guide blocks for Karat
core drilling machines features slide strips for fine
tuning on the drill stand.
•
Loosen the safety nuts
A
using the supplied
wrench 13.
•
Adjust the bolts
B
for an flexible sliding of the
guide block on the drill stand.
•
Secure then the bolts with the safety nuts
A
.
Drill stand fixation
CAUTION: The drill stand must
always be mounted firmly and
must not be able to move during
drilling.
Aligning the drill stand
•
Set up the drill stand at the drilling location.
•
Rotate the centering plate 28 forwards, until
it snaps in.
•
Align the drill stand in such a manner that
for the used machine the tip of the centering
plate is located directly above the required
drilling location.
•
Fasten the drill stand.
Secure using assembly
•
Drill the rawlplug hole Ø 15/16 mm (see
instruction rawlplug).
•
Insert rawlplug SD M12
•
Screw in assembly 30 .
•
Align the drill stand.
•
Fasten the drill stand with the spindle nut 29 .
Vacuum pump fixation
WARNING: Maximum drilling diam-
eter of 100 mm. Mount the drill
stand on an even, firm and smooth
surface using the vacuum pump,
never “over” head. Always connect
the core drill and the vacuum pump
to the same power outlet. Never
turn off the vacuum pump during
operation.
Position the machine horizontally. Maximum tilt of
10°. Fasten, mount suction hose and fasten with
hose clip.
See further the vacuum pump manual.
Mounting the drill bit
•
Tighten the clamping lever
24
.
•
Clean and grease the thread on the drill bit
31
and the drilling shaft
5
.
•
Screw a core bit 31 onto the drilling shaft 5
and tighten with supplied wrenches.
Connecting the water feed
•
Close the water tap 6 .
•
Connect the water feed hose to the water tap
or the water pressure tank.
•
When using the water pressure tank, make
sure that there is sufficient pressure when
working.
•
Check the waterflow indicator 9 .
Setting the drilling angle
•
Loosen the clamping lever
21
.
•
Use handle 23 to slide the column into the
desired drilling angle using the scale.
•
Tighten the clamping lever 21 .
Drilling
•
Always ensure a adequate anchorage in the
underground.
•
Open the water tap
6
.
•
Loosen locking lever 24 and hold the feed
lever
20
.
•
Actuate the ON/OFF switch 2 .
•
You can use the soft starter
3
at drilling start
Drill using an even forward feed. Do not over-
load the machine.
•
The leaking water should be milky and not
clear.
•
Always loosen the locking lever 24 when
drilling.
•
After drilling switch off the machine and shut