18
DIAMOND3
®
405TS-406TS
GB
on the saw spindle with a hexagon nut
to clamp the saw blade .
(Attention: Left-
handed screw thread)
Saw table
The saw table is constructed of welded
stainless steel components, equipped with
anti-slip rubber and adjustable side stop.
The saw table is equipped with 4 ball
bearing guide rollers for precise and easy
cutting feed .
Cooling system
The electrical water pump is switched on
simultaneously with the saw motor and
supplies cooling water to both sides of the
saw blade . A drain hole, with a plug, is
located in the water container. Mud flaps
prevent most of the water mist and make
sure most water flows back in the water
container .
6. UNPACKING AND SET UP
Setting up
• Unpack the sawing machine and
inspect for any damaged parts .
• Install the legs in the sockets at the
underside of the water container and
fasten with the knobs .
• Level the sawing machine by adjusting
the legs in the sockets and make sure
its stable .
• Release the transportation lock.
Saw head
• By loosening the lever the saw head
can be positioned at the desired
height .
Cooling system
ATTENTION!
Operating the water pump with-
out a sufficient supply of water
may result in pump damage.
• Place the plug in the drain of the water
container .
• Fill up the container with water until
the water pump is submerged till the
pumpgrip .
Connecting to power supply
First, check whether:
• the line voltage corresponds with the
data on the machineís specifications
plate,
• there is a grounded power supply,
• the extension cord wire cross-section is
at least 2,5 mm
2
.
Motor protection
The motor is equipped with a thermal
safety switch for protection against an
overload . When the motor gets over-
heated, the switch falls back into its initial