Rev: 03/2009
KNX-GSM Gateway
Page 13 of 19
©
b+b Automations- und Steuerungstechnik GmbH
KNX-GSM GATEWAY.DOC
Configuration with the EIBDoktor software
The KNX-GSM Gateway needs a correct configuration to work properly. This configuration can be
generated with the EIBDoktor software, the configuration data transfer can be done directly with the
EIBDoktor or with the ETS software.
Start the EIBDoktor software, and select the menu item „Options“
Æ
„KNX-GSM Gateway…“. The
following window will appear:
In the upper line you have to enter the serialnumber of the Gateway (can be found on the case of the
device), and the wanted physical address of the device. Additional you have to enter a „Parameter
group address”, this address will be used to send the gateway configuration to the device.
The button „Transfer to GW“ starts the device configuration. This button is only available if the EIB-
Doktor software is connected to the EIB with an EIBDoktor-EIBWeiche. If you do not have such a
bus coupling device available, you can save the current configuration by the button „Save to file…”.
This will also save a „.TEL“ file, which can be loaded and used in the ETS software, to transfer the
gateway configuration.
The button „Load from file…“ loads a saved configuration into the configuration window.
