B+B SMARTWORK SPECTRE V3, Руководство по настройке

Страница: 52 / 136

4. CONFIGURATION
4.6 WLAN Configuration
This item is available only if the router is equipped with a WiFi module.
The WiFi LAN and DHCP server page is displayed by selecting WLAN in the configuration
section. You will then be able to set the following properties (see table below). Use the
Enable
WLAN interface check box at the top of this form to enable WiFi LAN interface.
Item Description
Operating Mode WiFi operating mode:
•
access point (AP) – The router becomes an access point
to which other devices in station (STA) mode can be con-
nected.
• station (STA) – Router becomes a client station. It will re-
ceive data packets from the available access point (AP) and
send data from cable connection via the WiFi network.
DHCP Client Activates/deactivates DHCP client.
IP Address Fixed set IP address of WiFi network interface.
Subnet Mask Subnet mask of WiFi network interface.
Bridged Activates bridge mode:
•
no – Bridged mode is not allowed (default value). WLAN
network is not connected with LAN network of the router.
•
yes – Bridged mode is allowed. WLAN network is connected
with one or more LAN networks of the router. In this case,
the setting of most items in this table are ignored. Instead,
the router uses the settings of the selected network interface
(LAN).
Default Gateway IP address of the default gateway. When entering the IP address
of the default gateway, all packets for which the record was not
found in the routing table will be sent to this address.
DNS Server Address to which all DNS queries are forwarded.
Table 28: WLAN Configuration
43