AZZA 6IL, Руководство пользователя

Страница: 23 / 70

PT-6IL
MAINBOARD
HARDWARE SETUP
10
E
F
D
A. REMOVING BOXED PENTIUM™ II PROCESSOR
This section describes the BOXED PENTIUM™ II PROCESSOR removing
procedure. First, remove the mainboard from the chassis. To remove the processor
from the main-board, please use the following steps (the reverse of the installation
process).
1.
Disconnect the fan power cable from the mainboard. (We recommend that you
leave the cable connected to the processor.)
2.
Slide the clips on the supports backward to release the pegs in the mainboard. Push
the latches on the processor toward the center of the processor until they click into
place.
3.
Lift one end of the processor until it is free from Slot1. Lift the other end of the
processor until it is free from Slot1. Lift the entire processor (with the fan heat sink
supports attached) until it is free from the Retention Mechanism.
4.
Remove the heat sink support pegs from the mainboard and discard them. With one
hand, squeeze together the two halves of the peg on the bottom side of the
mainboard. With the other hand, pull the peg out of the hole in the mainboard. Do
not reuse the pegs.
WARNING !