E. Display
In addition to showing the frequency and channel number, the display
[
l
] also shows other useful information.
The LCD segments on the left show the approximate remaining battery
life (from 1 to 3 segments) with 3 segments meaning maximum battery
power. The bottom segment will blink when the battery power falls to
less than 2.2V and indicates that it is time to replace the batteries.
Azden recommends the use of Alkaline batteries only.
Across the top of the display, up to 5 segments will illuminate depending
on the strength of the transmitted audio signal - from 2 (weak) to 5
(strong). The first (left) segment will light when the AUDIO switch is
turned to ON. The best audio is achieved when 4 to 5 segments are lit.
If all 5 segments are lit continually, the signal is too strong and could
overload the input of the receiver. Either move the microphone further
away from the sound source or reduce the microphone input gain [
i
].
The display can also show the total number of hours of use (change to
this display using the MODE [
g
] button). To start, after choosing the
TIME mode, press the UP [
h
] button until the display shows 00:00.
Then, each time the transmitter is turned ON the clock will keep track of
the total hours and minutes used. This is a handy way of keeping track
of battery life.
i
11
1200URX/Si
1200URX/VM
1200URX/AB
c
c
c
c
d
d
e
e
i
i
i
j
j
k
k
k
l
l
l
h
h
h
g
g
